|
I plug my dust collector into it, and I can flip the dust machine on, then the saw, do my cut and reverse the process shutting down. The bracket is a little confusing to figure out, especially if you read the instructions, so do what all guys do - don't use the instructions and just find a way to make it work. I ordered this switch for my new router table. Turns things on, turns them off. But it will mount into a t-slot for above-router-table mount - a great safety feature. While waiting for it to arrive, I found a Rousseau switch on sale at my local Woodcraft, so I got it. I found the Rousseau easier to mount on my specific router table, so I got the idea of mounting this Bench Dog switch near the right side of my table saw.
It, not infrequently, requires a couple attempts at master the flowing movement necessary to deactivate the lockout and move the switch to the ON position. I have mixed emotions about the switch's safety design, which makes it nearly impossible to accidentally move to the ON position. Regardless, that is a single handed (or finger) operation which, once you get used to the flowing movement required, is not significant and can be chalked up to as a [very] small price for the added safety. Little need be said about this except that it does what it is intended to do - it makes it far more convenient to turn an under-table mounted router on and off.These are designed to be be mounted every way but inside out. However, I inset mine into one of the router table legs, to get it fully out of the way, while leaving it accessible from the working area of the table.The only real drawback to these is the price, in light of that the job could be done with a standard light switch and 120VAC receptacle.
I expected better -- seeing as it's a BenchDog switch for a BenchDog router table -- and would not make this purchase again. The mounting scheme seems to be an engineering afterthought. After purchasing this switch, I found another for $13 that I'm sure would have served just fine.a far cry from this 40-something dollar mistake. The switch is good quality but that is to be expected for the price. The electrical cord could be a couple/three feet longer.
Plus much or all of Bench Dog items are Made in the USA. All of Bench Dog products are built the same - high quality. This is no exception, although expensive, sometimes I don't mind paying a little extra when you get quality.
You can bolt it to that piece of aluminum and you can move it slide and turn, depending on what side of the table you're going to work on. Well I did use better supporting material making it match my equipment and there's something about making your own stuff that's more satisfying. I wanted to use a switch and a miter slot and when I stumbled upon a BenchDog aluminum extrusion for the outer edge this was the perfect switch for it.
But then it was wasn't it, I just put it together and routed a hole where I wanted the plate to go. So much for saving money building yourself. Could just buy the thing all done and saved some time.
I've been working on what I wanted in a router table for awhile and decided to built my own router table into the right extension of my tablesaw which I built to my specifications. I have a router table that look like it was purchased. But if I really was interested in saving money I could have just bolted the router to a piece of plywood and clamped it in a vise.
Although I struggled with the price and thought about other options I went with this. That was an added bonus for me.So far so good.
|
